Sharkline Above Ground Pool Manuel d'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
STEP 10 – SQUARING THE STRAIGHT SIDES:
Now that the base of the pool is fully
assembled, make sure that the straight sides of the
pool are perfectly in line with each other. We refer
to this as squaring the pool. This is done by
measuring from the outside of the first oval
upright on one side, to the outside of the last oval
upright on the opposite side (the two oval uprights
farthest from each other.) When making these
measurements they should always be taken at the
lower 12" of the upright because the higher up in
the upright you go the less accurate the
measurements may be. Once you have that
measurement you should measure the two
opposite uprights the same way as shown in the
diagram. The two measurements should be
exactly the same. If they are not, adjust one entire
side as necessary. This is a very important step, do
not continue until the measurements are the same.
Yardmore
11
STEP 11 – LEVELING THE STRAIGHT SIDES:
The leveling of the straight sides is a very crucial part of a good installation. If this is not done accurately it
will cause a lot of problems for you.
The strap end channels are two inches deep. The top of the strap end channel needs to be level with the ground.
The bottom plates on the curved sides also need to be level with the ground.
One at a time we recommend digging the strap end channels into the ground. Once all of the channels on a
side are level, put a 2" x 8" x 16" patio block under the back of each strap end channel as shown. This must be
done for each strap end channel. Remember the block is two inches deep and so is the end channel. You will need
to dig down a total of 4" where the block is in order to get the top of the strap end channel to ground level.
Once you have completed one entire side, do the same for every strap end channel on the opposite side. After
that is complete it is a good idea to check that your oval uprights are all level from top to bottom by using a
carpenters level. The pressure plates and straight side bottom rails ensure that your bottoms are still 42" on center.
Be sure that the tops of the oval uprights are as well.
Yardmore
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire