STEP 5: PRE-ASSEMBLY
In this step, you will use the wall carton as a base to unravel the pool wall. Locate the area that you wish to put the skimmer and return
so that you can start the wall behind the appropriate upright. Unravel the wall a little at a time, inserting into the bottom rails as you go. Do
not unravel the entire wall at once, for this makes installation much more difficult. As you unravel the wall you will need something to hold
it up. We recommend placing landscaping stakes around the outside of the pool and clipping the wall to the stakes as you go. If you
cannot get landscaping stakes the other option is to temporarily install stabilizer rails and uprights to keep the wall in place.
If the side wall seems too long or too short, make the bottom ring larger or smaller by equally sliding the bottom rails in or out of the
bottom plates. If the ground is uneven, the wall may jump out of the bottom track. Correct this condition by rechecking the level.
*
Top Plate
STEP 6: WALL INSTALLATION
Upright
Put front screw of top
plate in loosely
Metal coping
installed to
support wall
temporarily
Cardboard
Base
You may hide wall joint behind an
upright, but this is not required.
Use stakes to support wall
Check neon
wall label
for the right
end up
Make sure
skimmer and
skimmer return
holes are
unobstructed by
uprights, and are
at the upper
portion of the wall.
This is a good time to start the pre-assembly of the uprights. It is easiest to line all uprights next to each other in a line. It
helps to lean them against a fence or some other sturdy object. On most models the top of the uprights can be identified by
either an extra hole in the middle, or by an extra hole on each side (depending on which pool you have) for the decorator caps.
Place the metal top plate on the upright making sure the holes line up and the hooked part of the plate is facing the open end of
the upright (the side that goes against the pool wall). Now put a #10 x ½” screw in the center hole only. Do not install screws in
the two side holes until later. This will make things easier and more efficient later down the line.
Now would be the time to install the fence post holders onto the uprights, if you have purchased a fence to go around your
pool (see separate instructions). If not, or when that is completed, you should line the uprights around the pool at every
bottom plate or bottom cuff for your convenience later on.
*This is one example of a top
plate. The plate for your pool
may look a little different.
Rails can be slid in or out
from the stops on the bottom
plates or cuffs to adjust for
wall length being a little off.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels